User's Manual
Table Of Contents
- Contents
- Safety Notice
- 1 Introduction
- 2 Setup
- 3 Data Structure
- 4 Web Control
- 5 PandarView
- 6 Communication Protocol
- 7 Sensor Maintenance
- 8 Troubleshooting
- Appendix I Channel Distribution
- Appendix II Absolute Time and Laser Firing Time
- Appendix III PTP Protocol
- Appendix IV Phoenix Contact
- Appendix V Nonlinear Reflectivity Mapping
- Appendix VI Certification Info
- Appendix VII Support and Contact
34
4.3.2 For each channel
Users can configure one continuous angle range for each channel.
Outside the specified range for each channel, there will be no laser firing or data generated in that channel.
By default, the status button for each channel is green, indicating that angle range configuration is active.
To deactivate the angle range configuration for one channel, click the corresponding button to make it gray. Thus the angle range for this channel
becomes [0°，360°].
Click the “Enable/Disable All” button to activate/deactivate the angle range configuration for all channels.