User's Manual

25
4.3 Angle Range
Users can set azimuth angle range in the “Angle Range” tab. There are two methods to set angle range: LiDAR based angle range method and laser
based angle range method.
Figure 4.3 Angle Range Page
 LiDAR Based
If LiDAR based angle range method is selected, the start and end angles that users enter will be applied to all 64 channels. In other words, all 64 channels
will have the same angle range. There will be no laser firing or data generated outside the specified angle range. After setting, click “Save”.
NOTE Please do not forget to click “Save” after finishing setting. Otherwise, angle range will not be applied.