User Manual
22 23
4 SCR Scrambler
ON Scrambler Function Enabled
OFF Scrambler Function Disabled
5 TOT TX Time Out Timer 15 > 600 secs 15 second steps
6 APO Auto Power O
30, 60 > 300 minutes
Time Set that radio will Power O after last signal
received.
OFF Turn o APO Option
7 WN Bandwidth
Wideband 25.0 kHz
Narrowband 12.5 kHz
8 ABR Unused Setting
9 BEEP Keypad Voice Prompt ON / OFF Turn ON / OFF keypad voice prompt
10 R-DCS
Receive - Digital Coded
Squelch
D023N > D754I Squelch opens when proper DCS code is detected
OFF No DCS code required
11 R-CTCS
Receive - Analog Tone
Squelch
67.0 > 254.1Hz Squelch opens when proper CTCSS tone detected
OFF No CTCSS tone required
12 T-DCS Transmit - DCS Code
D023N > D754I Transmits specied code
OFF No DCS code transmitted
13 T-CTCS Transmit - CTCSS Code
67.0 > 254.1 Hz Transmits specied tone
OFF No CTCSS tone transmitted
14 DTMFST
Determines when DTMF
codes are heard through
speaker
OFF No DTMF tone heard
DS-ST Only manually keyed DTMF codes are heard
ANI-ST Only automatically keyed DTMF codes are heard
DT-ANI All DTMF codes are heard
15 BCL Busy Channel Lockout
ON Prevents transmit if active signal on the channel
OFF No lockout
16 SC-ADD Add Scan Channel
ON Add channel to scan list
OFF Remove channel from scan list
17 SC-REV Scan Resume Method
TO
(Time Operation) Scan stops when signal detected.
The scan resumes after approximately 5 seconds
(even if the channel is still active).
CO
(Carrier Operation) Scan stops when signal
detected. Scan resumes when signal disappears.
SE
(Search Operation) Scan stops when signal
detected. Scanning will not resume.
18 OPTSIG Optional Signaling
OFF No optional signaling
DTMF DTMF signaling selected
2TONE 2TONE signaling selected
5TONE 5TONE signaling selected
19 SPMUTE Speaker Mute Settings
QT Squelch opens for CTCSS/DCS tones only.
AND
Squelch opens when CTCSS/DCS tone is
recognized along with the optional signaling.
OR
Squelch opens when either the CTCSS/DCS tone
OR the optional signaling is recognized.