Instructions / Assembly

010421
Visit www.hessaire.com for How -To videos
1) Ensure unit is turned off and unplugged.
2) To change back side media pads, remove phillips screws
from upper back side. Media keeper pins are used for
certain models which will need to be removed to free up
pad. If no media keepers are present, pads will simply tilt
and pull out.
3) For models MC26 & MC37/M150, side media pads are
removed from the back inside. Note: Pads on the MC37M/
M150 are easier to remove if the fan blade is taken off first.
4) For models MC61/M250 & MC92/M350, side media panels
are taken out by removing the phillips screw from the upper
outer side grill panel to access pad. Once the side grill is
removed, the pad simply tilts and lifts out.
5) Reverse steps to install new replacement media pads.
Ensure all side/back grill panels, media pads and
screws are securely in place before operating cooler.
Covers Most Models
Hessaire Pad Replacement Instructions
Always unplug unit from power source before performing any maintenance. Failure to
do so could result in serious injury, electrical shock or death. Ensure back access panel and all parts are
securely fastened back in place and nothing is obstructing the fan blade prior to powering the unit up again.
See warning label on back of cooler prior to servicing.
Remove 2 phillips screws
Push panel up
Pull bottom out and down
Remove
back
pad(s)
Unscrew pad
retaining clips
where applicable
Pull pad
pins from
cooler
exterior
Suggested Tools:
#2 phillips screwdriver
Remove side
media pad
Remove Screw(s)
On Side Panels
Of Larger Models
To Access Side
Media Panels