Instructions / Assembly

INSTRUCTIONS FOR REPLACEMENT OF COOLER PADS
1. OPEN UNIT UP
2. REMOVE OLD PADS
Locate media pegs and remove.
Or pull
clips off
pegs from
the interior.
Using pliers,
pull plugs out
from the exterior.
NOTE: New plugs and clips are included
in replacement kit. Dispose of used pads,
plugs and clips.
3. INSTALL NEW BACK PAD
Position large pad inside the back grill.
Install new pad by pushing pegs
over rib in back grill and through
media pad, then pushing a
clip onto each peg.
(Location of 5 pegs
for back pad.)
4. INSTALL NEW SIDE PADS
Install each
side pad
using 2 pegs
and clips.
Locate pegs at
top and bottom
for best support.
Peg
Clip
Position small sections of the pad in the
sides of the back grill.
A . Remove 4 screws
from back of unit
B. Push up on back of unit.
C . Pull back of unit away