Use and Care Manual

LIGHTING INSTRUCTIONS

Hestan Grills feature hot-surface igniters for all Trellis Burners

™

, and infrared Rotisserie and Sear

Burners. The hot-surface igniters feature a “time-extender” function which maintain the hot

glow of the igniter for a longer period of time to ensure successful lighting of the burners.

Note: The time extender feature applies to the main burners only, not the rotisserie.

If your grill is equipped with a Hestan Side Burner, it features a spark-ignition system with flame-

sensing technology which will relight the flame should it go out.

All burners can be manually lit should that become necessary.

CONTROL KNOB LAYOUT

Seen here is a typical layout (36” model shown, Fig. 6) for the control knobs. The rotisserie

control is always to the far left side. Control panel LED lights and rotisserie motor switches are

on the far right.

The lighting instructions for all burners are visible when you pull out the drip tray.

LIGHTING GRILL BURNERS (Trellis Burner

™

or Sear Burner)

1. Read Use & Care Manual before lighting. Open lid during lighting. Stand as far away as

possible when lighting.

2. Push & hold selected knob for 5 seconds, then turn to “HIGH”. Burner should light. Once lit,

adjust flame as needed.

3. If burner does not light in 5 seconds, turn knob to “OFF” and wait 5 minutes before

re-lighting.

4. If burner fails to light, see USE & CARE MANUAL for match lighting instructions.

LIGHTING ROTISSERIE BURNER

1. Push & hold the knob for 5 seconds, then turn to the “HIGH”. Continue to hold in the knob

for at least 30 seconds after lighting. Rotisserie burner should stay lit and begin to glow.

Release the knob, burner should stay on.

2. If burner does not stay lit, turn knob to “OFF” and wait 5 minutes before re-lighting.

3. If burner fails to light, see USE & CARE MANUAL for match lighting instructions.

Figure 6