Installation Instructions

LOCATING THE SUITE

When determining a suitable location for your suite, take into account concerns such as exposure

to wind, rain, sprinklers, proximity to traffic paths, and keeping any gas supply line runs as short

as possible.

Locate the grill only in a well-ventilated area. Never locate the grill in a building, breezeway, shed

or other such enclosed areas without an approved ventilation system. Never locate the grill over,

under, or next to unprotected combustible construction.

During heavy use, the grill will produce a lot of heat and smoke. The grill is designed to take in

cool air at the front control panel area, and send the combustion products and smoke out the

exhaust gap at the rear of the hood. It is important to maintain this flow at all times. Using the

grill in windy areas can disrupt this proper flow and cause damage to your grill, or result in burn

hazards to the user. See Fig. 1 for details.

The Hestan Outdoor Living suite features ventilation openings (louvers) on each end. These

openings must be clear to avoid accumulation of gas should there be a leak. These openings are

further described later in this manual.

Figure 1

CURB INSTALLATION

1. The Hestan Outdoor Living Suite must be located on a level concrete or masonry patio

surface, not on direct soil. A licensed plumber and electrician should run their service

lines to the suite area prior to installation of the curb, in accordance with local codes. See

dimensions below for recommended location. See ELECTRICAL ITEMS section of this

manual for details. The gas line to the suite will require a shut-off that is easily accessible.

Local codes may also require a tracer wire be buried alongside the gas line for underground

detection. See the GAS CONNECTIONS section of this manual, and the appliance manual(s)

for more details.