Use and Care Manual

©2018 Hestan Commercial Corporation
34
EN
Figure 10 Figure 11
LIGHT BULB REPLACEMENT
1. Disconnect the power to your grill before any service or light bulb replacement. Be sure the
grill and the lights are completely cool. Halogen lights get extremely hot.
2. Open hood and remove the small screw holding the lamp assembly in place (Fig. 10). Remove
the lamp assembly, being careful not to drop the glass lens.
3. If needed, use a small flat-blade screwdriver to carefully pry off the lens and set aside. Loosen
the 2 screws closest to the lamp housing (Fig. 11). These screws hold the bulb in place. The
bulb should come out easily. The bulb is a 20W halogen “Bi-Pin” type, available at most
hardware stores & home centers.
4. Before installation, it is very important to clean the new bulb carefully with a clean, soft
cloth, or tissue paper. Grease, fingerprints, or oils in your skin can leave a residue on the glass
surface of the bulb which will create a hot-spot. The bulb will eventually crack at this hot-
spot.
5. While still using a cloth or tissue paper, install the new bulb in the housing and tighten the
screws. Check that the other tiny screws are tight as well.
6. Re-install the lens and return the lamp assembly to the hood. Carefully install the screw to
secure the assembly to the hood.
ADDITIONAL CONSIDERATIONS
Always keep the area around the grill free of obstructions and debris. Maintain at least 12”
(30 cm) of space around the grill to ensure proper airflow, and keep all ventilation openings clear
and free of debris. Clean appliance after each use, and check for blockages, especially at the
burner orifices, after periods of prolonged non-use. To maintain the appearance of your Hestan
grill for many years, keep it covered when not in use. Backyard environments are harsh on your
grills’ finish. Long exposure to sun, water, yard chemicals and the elements could diminish the
appearance of the stainless steel. This is very evident in ocean-front locations.
Our appliance materials have been tested in saline solutions with higher salinity than seawater.
They have also been tested by exposure to highly acidic foods. During and after these tests, we
found these materials were able to withstand exposure over prolonged periods of time. However,
the above-mentioned corrosive substances, along with neglect, can lead to a situation whereby
conditions might combine to cause some damage to occur. Therefore, we suggest that you always
keep your grill clean, dry and covered when not in use. This is even more important when long
term storage is required. Always store the grill clean, dry and covered with your Hestan Grill
Cover. A dirty grill will attract insects and rodents which is highly unsanitary. In addition, rodents
are known to chew on the insulation of wiring which will cause permanent damage to the wiring
and possibly electrical components.
For those in desert communities, wind-driven sand is highly abrasive and constant exposure will
eventually pit and scratch the surface. Another reason to keep your grill covered when not in use.
CLEANING AND MAINTENANCE
(continued)