Installation Manual

FINAL INSTALLATION

(CONT.)

MOUNTING THE HANDLES AND ENDCAPSMOUNTING THE HANDLES AND ENDCAPS

Handles and endcaps are provided with all stainless and color models. Handles are located in

protective wrapping, taped to the back of the refrigerator. Remove the handles before moving

the refrigerator into its cut-out or opening. Endcaps are located in a cardboard box inside the

refrigerator.

It is recommended that two people work together to assemble and apply the handles and

endcaps. Follow the steps below to complete the mounting process.

Insert the handle into the endcaps and rotate as

needed to align the notch in the tube, with the

tab inside the endcap. A light tap with a wood

or plastic hammer will help insert the tube fully.

Position the endcaps over the supports that are

pre-mounted on the door and drawer face.

• Use caution not to scratch the door surface.

• It is recommended that one person holds

the handle and endcaps in position while the

second person inserts the provided set screws

used to secure the handle.

The provided set screws are located in the box

with the endcaps. Using a 2.5 mm hex wrench,

insert the set screw into the hole in the endcap

and carefully tighten. The endcap is then properly

secured to the door/drawer. Repeat this step for

the other endcaps.