Installation Manual
Table Of Contents
- SAFETY PRECAUTIONS - BEFORE YOU BEGIN
- MODEL NUMBERS
- RATING LABEL
- REGULATORY / CODE REQUIREMENTS
- IMPORTANT CHILD SAFETY
- LOCATION AND PREPARATION
- CONNECTIONS
- Overlay Panels
- FINAL INSTALLATION
- TESTING AND INITIAL START UP
- PARTS AND SERVICE
- PRÉCAUTIONS DE SÉCURITÉ - AVANT DE COMMENCER
- numéros de modèle
- PLAQUE SIGNALÉTIQUE
- EXIGENCES RÉGLEMENTAIRES / CODE
- POUR LA SÉCURITÉ DES ENFANTS
- Lieu et préparation
- CONNECTER
- PRÉPARATION DES PANNEAUX DÉCORATIFS
- Installation finale
- ESSAIS ET DÉMARRAGE INITIAL
- LISTE DES PIÈCES
- SERVICE
LOCATION AND PREPARATION
(CONT.)
CUT-OUT DIMENSIONS AND INSTALLATION METHODS - NON-FLUSHCUT-OUT DIMENSIONS AND INSTALLATION METHODS - NON-FLUSH
If installing non-flush, the same side trim is used and the same cutout width is required.
A A
24: 23-3/4” [600]
30: 29-5/8” [750]
36: 35-1/2” [900]
A: Lateral / side connection kit
(SEE NOTE ON PG. 27)
A
1/4” [6,5]
3/8” [10]
18: 17-3/4” [451]
CONNECTIONS
ELECTRICAL AND WATER CONNECTIONELECTRICAL AND WATER CONNECTION
Do not use extension cords and/or multiple adapters for the power supply connection.
Do not use extension cords or adapters.
The built-in Hestan filter cannot make any water safe to drink, it must be used with water that
is already suitable for human consumption.
Water supply alarm:Water supply alarm:
If the water supply must be turned off after the the appliance is fully installed, connected to
the water supply (if applicable) and operational, touch the On/Off switch
to turn the unit
off first to avoid a ‘NO WATER IN’ alarm.
© 2020 Hestan Commercial Corporation
12
EN