Use and Care Manual

Table Of Contents

INTERNAL LAYOUT

FRESHSELECTFRESHSELECT

™™

, LOW-TEMP DRAWERS, LOW-TEMP DRAWERS

The FreshSelect

™™

drawer is held to the slide guides by a thumbscrew

on each side. Release the thumbscrews to remove the drawer.

To remove the inner drawer unscrew and remove its thumbscrews.

When replacing the drawer, make certain the back of the drawer

engages under the clips on the slide guides. Once the drawer is

properly in position, reinstall the thumb screws as they are necessary

to keep the drawer in place.

ICE TRAYICE TRAY

The ice tray is located in the upper drawer of the freezer

compartment.

After removal, make sure to reposition it correctly - small protrusions

from the bottom of the ice bin should align with holes in the upper

freezer drawer.

Do not place hands or fingers near the ice maker when it is functioning.

EXTENDFRESH DRAWERS (KRP & KRB Models only)EXTENDFRESH DRAWERS (KRP & KRB Models only)

The ExtendFresh drawer is held to the slide guides by a

thumbscrew on each side. Release the thumbscrews to remove

the drawer.

ADJUSTABLE SHELVES (KRP, KRB, KRC Models only) ADJUSTABLE SHELVES (KRP, KRB, KRC Models only)

It is recommended that the shelves be emptied prior to adjusting the

position. The shelves are able to slide up and down and can be easily

re-positioned by the user as follows:

1) Slightly loosen the small locking knob (located under the shelf on

the left side at the back) by turning it counter-clockwise.

2) Support the back of the shelf and tilt it upward at the front. This

will allow you to raise or lower the shelf to the desired position.

3) Once in position, lower the front of the shelf and tighten the

locking knob.

• The locking knob keeps the shelf locked safely in position. If the

locking knob is loose, the shelf could slide down if it were raised

or tilted upward at the front.

ADJUSTABLE SHELVES (KFC Models only) ADJUSTABLE SHELVES (KFC Models only)

Freezer models feature traditional shelf ladders left and right, which

are adjusted by lifting the shelf upward and raising to the desired

position - there is no locking knob.

To remove a shelf:To remove a shelf:

1) Remove the top cap of the left and right side ladder

2) Tilting the front of the shelf upward, slide the shelf to the top to remove.

• It is not necessary to remove the shelves for cleaning.