Installation Manual

FINAL INSTALLATION

(CONT.)

MOUNTING SAFETY ANTI-TIP BRACKETS - KRP series MOUNTING SAFETY ANTI-TIP BRACKETS - KRP series

To avoid danger of the appliance tipping over it is

mandatory to secure the appliance to the wall by

means of the two provided brackets.

1) The appliance has one screw in place where each

bracket will attach. (See figure to right.) Remove

the screws and set aside.

2) Determine location of brackets and mark the

wall accordingly. Note that the brackets can be

installed facing in or out, as preferred.

3) Roll the unit away from the wall, and mark the hole

locations.

4) Drill anchor holes and install the anchors.

5) Mount the bracket to the wall, then roll the

appliance into position and attach the bracket

to the appliance using the screws saved from (1)

above.

In addition, it is suggested:

• The side trim pieces on both sides must be

secured to the unit with the provided screws

• The side trim pieces must be screwed to the

cabinets at all provided attachment points.

• The cabinet must be securely attached to the wall

to assure the stability of the appliance.

When two units are installed together, the anti-tip

brackets are required for each of them.

In addition, the correct joining kit must be installed

and the units must be secured to the adjoining

cabinets by means of the side trim pieces, as above..

Anti-tip

mounting

screws