Use and Care

ELECTRICAL SUPPLY

This appliance features a battery-powered ignition system. To replace the battery, simply unscrew the

silver cap on the igniter button, remove the old battery, and replace with a fresh AAA battery. Note

the NEGATIVE end of the battery goes in first.

BURNERS

The main burner assembly is a unique design with 3 vertical venturis and a round perforated flame

spreader above. It does not have any adjustments.

Each Pizza Oven is tested at the factory prior to shipment. The proper orifices for the gas type

were installed at this time. However, variations in the local gas supply, the elevation where you live,

converting from one gas type to another, and other factors might affect the burner flames.

Flames should be blue and stable with no yellow tips (LP units will have some yellow tipping). There

should be no excessive noise or flame lifting. If any of these conditions exist, use a small mirror to

check inside the venturis for dirt, debris, spider webs, etc., that may be blocking the venturi. See

BURNER MAINTENANCE for details. The occasional orange flame that quickly goes away is usually a

small amount of dust or water condensation which is burning off - this is normal.

The Pizza Oven uses a standing pilot flame to light the main burner. There is a spark electrode and

flame sensor/thermocouple all in one assembly. This small pilot flame also has no adjustment. See

LIGHTING INSTRUCTIONS for more information.

PILOT

ORIFICE

VENTURI

FLAME SPREADER

GAS AND ELECTRICAL CONNECTIONS

(cont.)