Use and Care

PORTABLE LP GAS CYLINDERS

(cont.)

LOCATING AND ASSEMBLING THE PIZZA OVEN

When determining a suitable location for your Pizza Oven, please consider things such as exposure to

wind, rain, sprinklers, proximity to traffic paths, and keeping any gas supply lines as short as possible.

Locate the Pizza Oven only in a well-ventilated area. Never locate the Pizza Oven in a building, garage,

breezeway, shed or other such enclosed areas without an approved ventilation system. Never locate

the Pizza Oven over, under, or next to unprotected combustible construction. During heavy use, and

depending on what you are cooking, the appliance can produce a lot of heat and smoke.

Using the Pizza Oven in windy areas can disrupt the pilot flame or the main burner, causing it to go

out. Relocate to a less windy area. If the Pizza Oven is mounted in an enclosure, you may need to

build a wind-break to avoid this issue in the future.

When installing a Pizza Oven or other gas appliance into/onto an enclosure, the enclosure must be

constructed with ventilation openings to avoid accumulation of gas beneath should there be a leak.

See the INSTALLATION section of this manual for details. Keep the area underneath the Pizza Oven

free of debris.

Ensure all packaging, straps, etc. have been removed from the Pizza Oven.

The LP gas cylinder must be:

1. Constructed and marked in accordance with the specifications for LP gas cylinders of the U.S.

Department of Transportation (DOT) or the Standard for Cylinders, Spheres and Tubes for

Transportation of Dangerous Goods, CAN/CSA-B339, as applicable; and

2. Provided with a listed Overfilling Prevention Device.

3. Provided with a cylinder connection device compatible with the connection for outdoor cooking

appliances. The cylinder must be provided with a shut off valve terminating in an LP gas supply

cylinder valve outlet specified, as applicable, for connection type QCC1 in the standard for

compressed gas cylinder valve outlet and inlet connections ANSI/CGA-V-I.

Certain liquid propane dealers may fill LP cylinders for use in the grill beyond cylinder filling capacity.

This “overfilling” may create a dangerous condition due to a build-up of excess pressure. As a safety

device, there is a pressure relief valve which will vent propane gas vapor to relieve this excess pressure.

This vapor is combustible and therefore can be ignited. To reduce this danger, you should take the

following safety precautions:

1. When you have your cylinder filled, be sure you tell the supplier to fill it to no more than 80% of its

total capacity.

2. If you own or use a spare cylinder, you should NEVER store it near or under the appliance unit or

burner box, or near any other ignition or heat source (like a water heater or furnace).

IF THE INFORMATION IN 1 AND 2 ABOVE IS NOT FOLLOWED EXACTLY, A FIRE CAUSING

DEATH OR SERIOUS INJURY MAY OCCUR.

3. The LP cylinder must be disconnected and stored OUTSIDE in a well-ventilated area, out of the

reach of children.

4. Do not store a full cylinder in direct sunlight.