Paper Towel Installation Instruction

©2016 Hestan Commercial Corporation
1
EN
PAPER TOWEL DISPENSER
Installation Instructions
AGPTD16
IMPORTANT - READ ALL INSTRUCTIONS BEFORE YOU BEGIN
INSTALLER SHOULD LEAVE THESE INSTRUCTIONS WITH THE HOMEOWNER
Some parts have sharp edges. Care must be taken when handling the various components to avoid
personal injury. Wear gloves when handling.
TOOLS REQUIRED:
Work gloves
Safety glasses
Electric drill with assorted bits for mounting hardware, masonry anchors, etc. where needed
Phillips screwdriver
Flat-blade screwdriver
Level
Tape measure
Inspect the product to verify that there is no shipping damage. If any damage is detected, call the shipper
and initiate a damage claim. Hestan Commercial Corp. is not responsible for shipping damage. DO NOT
discard any packing material (box, pallet, straps) until the unit has been inspected.
Remove all exterior packaging materials, banding, tape, etc. Remove all protective film from the inside of
your cabinets. You may leave any exterior protective film on until after installation is complete.
INSTALLATION
1. Your new Hestan Paper Towel Dispenser may be installed in 3 different orientations as shown below.
Consult the table at the end of this instruction manual to determine the appropriate cutout dimensions
for this product. The cutout should be square at all corners for proper fitment. The installer will have to
build up any internal structural elements or supports in the island in order to secure the product in place.
Stainless steel hardware (not included) is highly recommended.

Summary of content (6 pages)