Use and Care Manual

©2021 Hestan Commercial Corporation
16
EN
1/2” ID FLEX HOSE
& NIPPLE
(SUPPLIED BY CUSTOMER)
NAT GAS
REGULATOR
(SHIPPED LOOSE)
INCOMING
NAT GAS SUPPLY
SHUTOFF VALVE
(SUPPLIED BY
CUSTOMER)
TYPICAL ASPIRE GRILL
(36” MODEL SHOWN)
Your Aspire grill for use with
Natural Gas is supplied with its
own regulator which MUST be
installed. If this regulator needs
to be replaced, use only the type
specified by Hestan for this
appliance.
To connect the regulator / hose
assembly follow the next steps:
1. Locate the regulator and gas
connection point in the rear
right side of your grill (in cart-
mounted models, remove the
rear panel to gain access).
2. Install the natural gas
regulator as shown. Connect
gas supply using a minimum
1/2” diameter flexible (semi–
rigid) stainless steel gas hose,
no more than 48” [1.22m] in
length. The hose as well as
the connectors must comply with the
Standard for Connectors for Outdoor Gas Appliances and
Manufactured Homes, ANSI Z21.75 • CSA 6.27
, and suitable for outdoor installation. Use the
appropriate thread sealant on all connections.
3. Proceed to LEAK TESTING section.
GAS CONNECTIONS (continued)
GAS CONNECTION -
LIQUID PROPANE (LP)
CYLINDER
Your Aspire grill for use with LP
gas is supplied with a two-stage
regulator/hose assembly for
connection to a standard 20 lb. LP
gas cylinder. This assembly must
be used WITHOUT alteration. If
this assembly needs to be replaced,
contact your Hestan dealer for
genuine replacement P/N 014309.
NOTE:NOTE: To ensure proper
heating performance of this
appliance, verify that the supply
(inlet) pressure is adequate. Use
only the gas pressure regulator
supplied with this appliance.
This regulator is set to maintain
10 inch WC [2.49 kPa] oulet
(manifold) pressure.
2-STG. LP
REGULATOR / HOSE
ASSEMBLY
ADAPTER, 3/8 FLARE
X 1/2 NPT FEMALE
(SHIPPED LOOSE)
20lb LP TANK
(SUPPLIED BY
CUSTOMER)
TYPICAL ASPIRE GRILL
(36” MODEL SHOWN)