NG To LP Piped Systems Kit

MODIFYING REGULATOR

(continued)

2. Connect to your LP Piped System using a minimum 1/2” diameter flexible (semi-rigid) stainless steel

gas hose. The gas line connectors must comply with the

Standard for Connectors for Outdoor Gas

Appliances and Manufactured Homes, ANSI Z21.75 • CAS 6.27

, and suitable for outdoor installation.

The connection shall be 6 feet (1.82 m) or less.

NOTE: To ensure proper heating performance of this appliance, verify that the supply pressure is

adequate (11.0” WC supply pressure is preferred) to maintain 10.0” WC manifold pressure.

GAS SUPPLY

The local gas authority or supplier should be consulted at the installation planning stage in order

to establish the availability of an adequate supply of LP gas. If it is a new installation, have the gas

authorities or supplier check the meter size and piping to assure that the unit is supplied with the

necessary amount of gas supply and pressure to operate the unit(s).

Gas connections should be made by a qualified plumber, or your professional outdoor appliance service

technician.

All fixed (non-mobile) appliances must be fitted with an accessible upstream gas shutoff valve as a means

of isolating the appliance for emergency shut off and for servicing.

Make certain new piping and connections have been made in a clean manner and have been purged so

that piping compound, chips, etc. will not clog regulators, valves, orifices, or burners. Use pipe joint

compound / thread sealant approved for LP gas.