Use and Care Manual

©2016 Hestan Commercial Corporation
25
EN
LIGHTING SIDE BURNERS
1. Read Use & Care Manual before lighting. Remove cover during lighting.
2. Stand as far away as possible when lighting.
3. Push and turn selected knob to “HIGH” position. Igniter will spark until flame is established.
4. Once lit, turn knob to desired flame setting. If spark does not occur, check electrical supply.
5. If burner does not light in 5 seconds, turn knob to “OFF” and wait 5 minutes before re-
lighting.
6. If burner fails to light, see USE & CARE MANUAL for match lighting instructions.
Note: The flame-sensing technology of the spark igniter will repeatedly spark (clicking sound)
until a flame is established. If you experience nuisance sparking during normal operation of
the burner, see the TROUBLESHOOTING section of this manual. A very low flame in windy
conditions is usually the cause of this nuisance sparking.
MATCH LIGHTING INSTRUCTIONS
If a burner will not light after several attempts, it can be lit with a match. Open the hood and
allow 5 minutes for any accumulated gas to dissipate from the grill. Use a long-stem fireplace
match, or attach a short match to the match lighting clip provided with your Hestan Grill
(see below Fig. 7).
Figure 7
When attempting to light a burner with a match, be sure you selected the correct control
knob for that burner. Keep your face away as far as possible, and pass the lit match through
the openings of the cooking grates and radiant trays and position near the burner ports. Push
and turn the control knob to “HIGH” until the burner lights. Repeat this procedure for each
burner if necessary. If the burner does not light in 5 seconds, turn the control knob to “OFF”
and wait 5 minutes before trying again. If the burner will not light after several attempts, see
the TROUBLESHOOTING section of this manual. Side burners can be lit in the same manner,
although a long match may not be needed.
In sunny locations, infrared Rotisserie and Sear Burners may be difficult to see if they are lit.
After attempting to light, you can very carefully wave your hand 8-10 inches (20-25 cm) away
from the burner surface to feel the heat of the burner. If there is no heat, OR IF YOU SMELL
GAS, shut off the control knob and wait 5 minutes before attempting to re-light.
LIGHTING INSTRUCTIONS
(continued)