Use and Care Manual

GAS CONNECTION - NATURAL GAS (NG)

NOTE: To ensure proper heating performance of this appliance, verify that the gas line supply

pressure is adequate. Use only the gas pressure regulator supplied with this appliance. This

regulator is set for a supply (inlet) pressure of 7-14 inch WC [1.74-3.48 kPa] to maintain 4 inch WC

[1.00 kPa] nominal outlet (manifold) pressure. Use the supplied 10 ft [3 m] gas hose to prevent

gas starvation. Ensure that the service pipe supplying the appliance is fitted with a shut-off valve

conveniently positioned and easily accessible as an emergency gas shut-off.

Your Hestan grill for use with Natural Gas is supplied with its own regulator which is pre-installed

inside the unit. If this regulator needs to be replaced, use only the type specified by Hestan for this

appliance. The 10 ft. [3 m] long hose is also pre-installed at the factory. Locate your gas connection

point near the rear of your grill. The hose as well as the connectors must comply with the

Standard

for Connectors for Outdoor Gas Appliances and Manufactured Homes, ANSI Z21.75 • CSA 6.27

and suitable for outdoor installation. Use the appropriate thread sealant on all connections.

It is assumed you have a stationary incoming gas supply located near the rear of the unit, with a

shutoff valve pre-installed (see above image). To connect the hose assembly follow the next steps:

1. Remove the quick-disconnect coupling of the hose by sliding back the black sleeve. Install

this brass section onto the shutoff valve with appropriate thread sealent. See instruction tag

supplied with the hose for more detail.

2. Re-connect the coupling of the hose. Open the shutoff valve.

3. Proceed to LEAK TESTING section.

GAS CONNECTIONS

(continued)

10 ft FLEX HOSE w/

QUICK DISCONNECT

INCOMING

NAT GAS SUPPLY

SHUTOFF VALVE

(SUPPLIED BY CUSTOMER)

HESTAN DELUXE GRILL