High Altitude Kit Guide

©2017 Hestan Commercial Corporation
3
EN
3. When replacing the elbow and orifice assembly back into the burner bracket, it is important to
maintain the original spacing shown below for proper burner performance.
.25” (6.3 mm)
CHANGING ORIFICES
(continued)
4. Remove the screws securing the control panel to the front of the grill. Carefully tilt down the
control panel being careful not to damage the wires to the switches and LED light bar. Pull off the
connectors to the 2 switches and the LED light bar at this time. Remove the control panel from the
grill and set aside.