LP Portable to LP Piped Systems Kit Guide

1. As shown below, disconnect the small LP tank, remove the hose assembly, and remove the brass

adapter fitting from the manifold pipe at the rear of the appliance.

CHANGING REGULATOR (FOR UNITS WITH PORTABLE LP TANKS)

TYPICAL HESTAN GRILL

(36” MODEL SHOWN)

ADAPTER, 3/8 FLARE

X 1/2 NPT FEMALE

20lb LP

TANK

2-STG. LP

REGULATOR / HOSE

ASSEMBLY

An LP piped system is one with a large central LP tank that feeds an entire household. These systems are

normally equipped with a high pressure regulator by the large LP tank, and low pressure regulators close

to the home.

This kit is to be used if your Hestan or Aspire grill or side burner was already supplied with a 2-stage LP

regulator / hose assembly. The kit includes a special regulator for use with LP Piped systems.

2. Install the new LP PIPED SYSTEM regulator as shown below. Connect to your LP Piped System

using a minimum 1/2” diameter flexible (semi-rigid) stainless steel gas hose. The gas line connectors

must comply with the

Standard for Connectors for Outdoor Gas Appliances and Manufactured

Homes, ANSI Z21.75 • CAS 6.27

, and suitable for outdoor installation. The connection shall be 6 feet

(1.82 m) or less.

NOTE: To ensure proper heating performance of this appliance, verify that the supply pressure is

adequate (11.0” WC supply pressure is preferred) to maintain 10.0” WC manifold pressure.

NOTE: If you have a Hestan or Aspire Side Burner inter-plumbed with a Grill, you will follow these same

instructions.