Manualshelf

Use and Care

ManualsBrandsHestan ManualsBarbecue36 Inch Built-In Grill with with 653 sq. in. Grilling Area, 2 Trellis Tubular Burners, 1 Sear Burner, Rotisserie, 89,000 BTU, Horizon Spring Assisted Hood, Warming Rack, Temperature Gauge and Hot Surface Ignition: Liquid Propane / Matador
11121314151617181920
©2016 Hestan Commercial Corporation
18
EN
GAS CONNECTION - LIQUID PROPANE (LP) CYLINDER
Your Hestan grill for use with LP gas is supplied with a two-stage regulator/hose assembly
for connection to a standard 20 lb. LP gas cylinder. This assembly must be used WITHOUT
alteration. If this assembly needs to be replaced, contact your Hestan dealer for genuine
replacement P/N 014309.
NOTE: To ensure proper heating performance of this appliance, verify that the supply pressure is
adequate (11.0” WC supply pressure is preferred) to maintain 10.0” WC manifold pressure.
To connect the regulator / hose assembly follow these steps:
1. Locate the regulator and gas connection point in the rear right side of your grill (in cart-
mounted models, remove the rear panel to gain access).
2. Connect the regulator/hose assembly to the 3/8” Flare (compression flare fitting) X 1/2” NPT
female adapter as shown.
3. Connect the regulator/hose assembly to a standard 20 lb. LP cylinder. The hose as well as the
connectors must comply with the
Standard for Connectors for Outdoor Gas Appliances and
Manufactured Homes, ANSI Z21.75 • CAS 6.27
, and suitable for outdoor installation. Use the
appropriate thread sealant on all connections.
4. Proceed to LEAK TESTING section.
GAS CONNECTION - LP PIPED SYSTEMS
An LP piped system is one with a large central LP tank that feeds an entire household. These
systems are normally equipped with a high pressure regulator by the large LP tank, and low
pressure regulators close to the home. The gas line connectors must comply with the
Standard
for Connectors for Outdoor Gas Appliances and Manufactured Homes, ANSI Z21.75 • CAS 6.27
,
and suitable for outdoor installation. The connection shall be 6 feet (1.82 m) or less.
Please contact Hestan Customer Service to order an LP Piped System Kit for this unique
installation.
NOTE: To ensure proper heating performance of this appliance, verify that the supply pressure is
adequate (11.0” WC supply pressure is preferred) to maintain 10.0” WC manifold pressure.
GAS CONNECTIONS
(continued)