Manualshelf

Use and Care

ManualsBrandsHestan ManualsBarbecue36 Inch Built-In Grill with with 653 sq. in. Grilling Area, 2 Trellis Tubular Burners, 1 Sear Burner, Rotisserie, 89,000 BTU, Horizon Spring Assisted Hood, Warming Rack, Temperature Gauge and Hot Surface Ignition: Liquid Propane / Matador
21222324252627282930
©2016 Hestan Commercial Corporation
19
EN
LP TANK RESTRAINT
If you purchased a Hestan Grill on a cart, be sure to restrain the LP cylinder by securing it with
the retention bolt on the slide-out tray as shown below. It is important the tank does not fall
over or stretch the hose which could cause a gas leak.
LEAK TESTING
GENERAL
Although all gas connections on your Hestan grill are leak tested at the factory prior to
shipment, a complete gas tightness check must be performed at the installation site due to
possible movement in shipment, or excessive pressure unknowingly being applied to parts of the
unit. Periodically check the whole system for leaks, or immediately check if the smell of gas is
detected.
BEFORE TESTING
• Do not smoke while leak testing.
• Never leak test with an open flame.
• Make a soap solution of one part liquid detergent and one part water for leak testing
purposes.
• Apply the solution to the gas fittings by using a spray bottle or a brush.
• For LP units, always check with a full LP cylinder.
GAS CONNECTIONS
(continued)