Tubular Burner Conversion Guide

SEAR BURNER REMOVAL

1. Before you begin, remove the mesh screen. The small metal cover on the Sear Burner, and the rear

screw at the back of the firebox must also be removed. With extensive use, the screws may be

completely covered in burned-on grease and food debris, and the threads may have become stuck

making it very difficult to remove the screws. Use some penetrating oil to free the screws. Be

sure to use the appropriate socket which will grip the screw-head well. With the metal cover and

rear screw removed, remove the Sear Burner by lifting up the rear and carefully twisting to clear

the igniter. BE VERY CAREFUL WITH THE CERAMIC IGNITER! It has a perforated sleeve for

protection, however it can crack or snap off if you are not careful.

2. With the burner removed, you will see 2 threaded holes on either side of the igniter. Mount the new

shroud as shown below with the screws provided, but leave the screws loose temporarily.