Use & Care Guide

EN
©2021 Hestan Commercial Corporation
10
MAINTENANCE
SEASONAL MAINTENANCE FOR UL-APPROVED OUTDOOR MODELSSEASONAL MAINTENANCE FOR UL-APPROVED OUTDOOR MODELS
WINTERIZINGWINTERIZING
This process should occur when the daily low temperatures is at or below the temperatures stated
below:
Refrigerator models: 38°F [+3°C] Beverage Center/Beer: 42°F [+6°C]
Freezer models: 32°F [0°C] Wine Reserve: 45°F [+7°C]
It is best to winterize your unit before the low temperatures listed above.
1. Turn the unit to OFF position by pressing the OFF button on the controller. The controller
displays the word “OFF” and turn the master switch located behind the grille off (if the power
cord is accessible, unplug the power cord. If not, turn off the circuit breaker to the electrical
receptacle the cabinet is plugged into).
2. Remove all contents from the unit.
3. Remove the front grille.
4. Clean the condenser by using a vacuum cleaner to remove loose debris (leaves, dirt, etc.) that
may have accumulated inside the grille.
5. Reinstall the front grille.
6. Clean the interior of the unit using stainless steel cleaner and polish (see page 11).
7. Clean the exterior of the unit using stainless steel cleaner and polish (see page 11).
NOTE: Do not place a cover over the unit. While not required, you may choose to remove the unit
from the outdoor location and store indoors.
Operating the unit at temperatures lower than those recommended will void the warranty.
SPRING START-UPSPRING START-UP
This process should occur after the daily low temperatures is above the temperatures stated below:
Refrigerator models: 38°F [+3°C] Beverage Center/Beer: 42°F [+6°C]
Freezer models: 32°F [0°C] Wine Reserve: 45°F [+7°C]
1. Remove the grille.
2. Check the condensing unit to ensure it is clear of loose debris, and clean as necessary with a
vacuum cleaner.
3. Reattach front grille to the unit.
4. Clean the interior of the unit using stainless steel cleaner and polish (see page 11).
5. Clean the exterior of the unit using stainless steel cleaner and polish (see page 11).
6. Plug the unit into the electrical receptacle or turn on the circuit breaker.
7. Turn on the master switch located behind the grille. Press the OFF button one time to turn the
unit on. The controller display will show the actual temperature inside the cabinet.
8. The cooling process will begin to bring the unit to the set temperature. It is recommended you
run the unit for 24 hours to stabilize the operating temperature before using.
DANGER
Never attempt to repair or perform maintenance on the unit until the main electrical power has
been disconnected!
LED REPLACEMENTLED REPLACEMENT
To receive parts and/or service and the name and telephone number of the nearest Hestan
authorized service representative, please contact your Hestan dealer or distributor, or Hestan’s
Customer Service Department by calling 888-905-7463 or e-mailing [e-mail]