Use and Care Guide

FEATURES AND CONTROLS

(continued)

ADJUSTING THE RINSE-AID DISPENSER SETTING

ADDING DETERGENT

factory set for medium water hardness (selector set to “3”). To change the setting,

The rinse-aid dispenser can be set to one of 6 different levels. The dishwasher is

turn the dispenser selector (see previous page) to the desired position: the amount

of rinse-aid dispensed is proportional to the position of this selector. Make sure that

the minimum amount of rinse-aid (selector turned to “1”) is approximately 1 ml and

the maximum amount (selector turned to “6” ) is approximately 6 ml.

•

To adjust the rinse aid setting, rotate the dispenser cover a quarter turn in a

counter clockwise direction and remove it.

• Then use a screwdriver to rotate the rinse aid selector to the desired position.

• Replace the cover by turning it clockwise until it is fully closed.

• The amount of rinse-aid must be increased if the washed dishes appear dull or

have circular stains.

• If, on the other hand, the dishes are sticky or have white streaks, it is necessary to

reduce the rinse-aid setting.

DO NOT INHALE OR SWALLOW DETERGENT AS THIS MAY CAUSE

BURNS AND/OR PERMANENT DAMAGE TO THE NOSE, MOUTH AND

THROAT, AND EVEN LEADING TO SUFFOCATION; KEEP DETERGENT

AWAY FROM YOUR EYES. IF ONE OF THE ABOVE SITUATIONS OCCURS,

SEEK MEDICAL ASSISTANCE IMMEDIATELY.

PREVENT CHILDREN FROM COMING INTO CONTACT WITH DETER-

GENT;

KEEP THEM AWAY FROM THE DISHWASHER WHEN THE DOOR IS

OPEN AS IT MAY CONTAIN DETERGENT RESIDUES. FILL THE DISH

WASHER JUST BEFORE STARTING THE WASHING CYCLE AND THEN

KEEP THE DETERGENT OUT OF THE REACH OF CHILDREN.

To open the detergent dispenser cover, lightly press the release tab.

Add the detergent and close the cover carefully, pushing down on the arrow on the cover.

During the washing cycle, the dispenser will open automatically.

Dispenser release tab