Use & Care Manual

OPERATION

(CONT.)

INFORMATION DISPLAYED DISPLAY

Scheduled program duration

Remaining program time

Delayed start : 1 – 24 hours

Error message: Err

TURNING ON THE DISHWASHERTURNING ON THE DISHWASHER

Press the On/Off button (Item 1, “CONTROL PANEL” on page9) to start the dishwasher.

Then wait for one of the program indicator lights to turn on.

SELECTING AND STARTING A PROGRAMSELECTING AND STARTING A PROGRAM

1. For programs 1-5: press Select (Item 3, “CONTROL PANEL” on page9) several times until

the indicator light corresponding to the required program turns on (Items 2, same page)

2. Select options as needed (“1/2 Load”, “Energy Saver”, “Delay Start”) and close the door. The

program will start after a few seconds. The indicator light will flash while the cycle is running

(see “PROGRAM RUN PROJECTION INDICATOR” on page14).

SELECTING PROGRAMS 6-10SELECTING PROGRAMS 6-10

1. To run programs 6, 7, 8, 9, 10, select the corresponding standard program (1-5) and then press

the Quick Wash button (item 6 on page10) .

• For example, to select program 6, press “Select” until “Soak” is indicated, then press the

“Quick Wash” button.

2. Proceed as with programs 1-5.

IMPORTANTIMPORTANT

The door of the dishwasher must be closed within 4 seconds after use of the program selection

button (Select ) for all functions (e.g. program selection, change, deletion, etc.).

If the door is not closed within 4 seconds, the selected program’s indicator lights will flash rapidly

to indicate that the operation must be confirmed before the door is closed.

To confirm, simply press Select once. The indicators will blink slowly and you can close the door

to start/resume the dishwasher.

The same applies if the dishwasher is opened with Delay Start set and the cycle not started (e.g. to

add more dishes). Select must be pressed before the door is closed, restarting the program delay

countdown.

If the door of the dishwasher has not been closed or has been incorrectly closed, the washing

cycle will not begin. The “Program Run” light will be ON instead of flashing.

END OF WASH CYCLEEND OF WASH CYCLE

The end of the program is signaled by a short beep. Additionally, the indicator lights of the Daily

Wash and Super Sanitize wash programs will flash. The “Program Run” light will be OFF.