Use & Care Manual

OPERATION

(CONT.)

PROGRAM RUN PROJECTION INDICATORPROGRAM RUN PROJECTION INDICATOR

When a program is running, a flashing light is projected onto the floor under the right-hand corner

of the door.

• If the program is selected but not running, the light will be steady ON.

At the end of the program, the light goes out.

INTERRUPTING A WASH CYCLEINTERRUPTING A WASH CYCLE

To interrupt a wash cycle, open the dishwasher door. The cycle will be interrupted, the cycle’s

indicator lights will flash (blink rapidly) and a beep will indicate that the cycle has not finished.

To resume the wash cycle, press Select once (the indicators will then blink slowly) and then close

the door. When the door closes, the cycle will start from where it was interrupted. This operation

should be performed only if necessary as it could cause irregular performance.

CHANGING THE CURRENT WASH CYCLECHANGING THE CURRENT WASH CYCLE

To change the current program, simply open the door of the dishwasher and press Select to select

the new program. Close the door to run the new program automatically.

CANCELING THE CURRENT WASH CYCLECANCELING THE CURRENT WASH CYCLE

To cancel the current program:

1. Open the door then press and hold Select (the cycle selection button) for a few seconds until

the indicator lights of the fourth and fifth cycles turn on.

2. Close the door again.

The dishwasher will pump out and finish for about 1 minute. Then it will stop and the “Program

Run” light will go OFF. When you open the door, the indicator lights of the fourth and fifth cycle

will flash.

OPTIONS: OPTIONS:

These are functions to tailor the dishwasher program for your particular needs, such as delayed

start, Half load, and more. (For descriptions of the basic cycles, see “Wash Cycles” on page11.)

DELAY STARTDELAY START

• Available for all programs except Soak.

The DELAY START function delays the beginning of the wash cycle up to 24 hours beginning from

the moment the delay programming is entered. This makes it possible to use the dishwasher at a

specific time of day.

Before programming a delay, open the door of the dishwasher and select the required washing

program. Select the delay by pressing the Delay Start button. Each time you press the button, the

delay before the appliance starts is increased by 1 hour.