Use & Care Manual

OPERATION
(CONT.)
ADJUSTING THE WATER SOFTENING SYSTEMADJUSTING THE WATER SOFTENING SYSTEM
The dishwasher’s water softener can be adjusted to suit the hardness of the water it is supplied
with. The hardness is set using the Select (program selection) button.
The setting can be adjusted by holding the Select button down for 15 seconds until the ADD Salt
indicator light flashes, while the Selected Program indicator lights to show the current hardness
setting. Each press of the Select button changes the setting following the sequence in the Water
Hardness Table below:
After carrying out the adjustment or displaying the current setting, if you do not touch the button
for a few seconds the dishwasher will automatically exit from adjustment mode and return to the
standard operating mode.
The default setting is H3. Contact your local water agency for information on the hardness of
your water supply.
Crystal
Delicate
Daily Wash
Super/
Sanitize
Soak Salt
Rinse Aid
Select
ADD
Crystal
Delicate
Daily Wash
Super/
Sanitize
Soak Salt
Rinse Aid
Select
ADD
0-6
7-10
11-15
16-21
22-28
29-50
0-11
12-18
19-27
28-37
38-50
51-90
H0
H1
H2
H3
H4
H5
German
degrees (°dH)
French
degrees (°dF)
All lights off
One light on
Two lights on
Three lights on
Four lights on
Five lights on
WATER HARDNESS TABLE
WATER HARDNESS
SETTING
©2021 Hestan Commercial Corporation
17
EN