Use & Care Manual

LOWER SPRAY ARMLOWER SPRAY ARM

To remove the orbital spray arm assembly (C), take hold of the

lower arm (D) and pull the orbital unit upward.

After cleaning, place the orbital spray arm in its seat and push

it down slightly until it clicks into place on the lower spray

arm. Then place the lower spray arm into its seat and push it

down slightly until it clicks into place.

CLEANING THE FILTERCLEANING THE FILTER

Periodically remove the filter assembly (A) to

inspect it. To remove the filter, grip the tabs,

turn counter-clockwise and lift upwards.

The filter assembly consists of the outer micro-

filter (fine wire mesh) and a plastic center filter.

Push the center filter (B) from the underside to

remove it from the micro-filter.

To separate the two parts which make up the

plastic center filter:

1. Find the arrows (C) on the sides of the top

piece.

2. Press the body of the filter on each side just

below the arrows.

3. Remove the center filter by lifting it upwards.

As needed, clean all parts of the filter assembly under running water (at room temperature), using

a stiff brush.

After cleaning, reassemble and install the filter assembly:

1. Join the two parts comprising the center filter by pushing gently until they click into place.

2. Insert the center filter into the micro-filter.

3. Place the filter assembly (A) into its seat, turning it clockwise until it locks.

C C

CLEANING AND USER MAINTENANCE

(CONT.)