Installation Guide

TESTING AND INITIAL START-UP

(CONT.)

INITIAL STARTUP

Once the appliance is plugged in, the display should show .

Turn the appliance ON by pressing the Power button for three seconds. The display will

show the message “Initial test” for approximately 2 minutes. After this phase the compressors

will start up and remain on until the default temperature (set at the factory) is reached. Allow

ample time for the refrigerator to reach this temperature before loading any items (6-12 hrs).

Ice Maker

If the appliance is provided with an ice maker:

1) Make sure that the water filter cartridge is properly installed

2) Purge air from the water lines by enacting the ‘Manual Clean’ function from the Menu-

>Functions->Water Filter options. You may need to complete this sequence several times

until you stop hearing air sputtering from the ice maker fill tube.

3) Once the procedure has completed, turn the Ice Maker on by touching the button (KRP,

KRB) or by using the menu:

Bottom Drawer

Models KRP, KRB, and KRW have a bottom drawer which defaults to freezer operation. The

drawer can also be set to other modes of operation. See the Use and Care manual for more

information.

Readiness

If at first the Start Up message does not appear but other information in the display does

appear (such as Fridge too warm, Freezer too warm, or audible signals are heard), the

refrigerator has still begun the normal cooling process.

If this is the case, deactivate any audible signals by pressing the Alarm button, close the door

and wait until the set temperature is reached.

It is necessary to let the unit reach the correct temperature prior to placing food or beverages

in it. (Allow 6-12 hours.)

For further information about the appliance operation, refer to the Use and Care Manual.

OKOK

Turn icemaker ON

Turn icemaker OFF