Installation Manual
Table Of Contents
- SAFETY PRECAUTIONS - BEFORE YOU BEGIN
- MODEL NUMBERS
- RATING LABEL
- REGULATORY / CODE REQUIREMENTS
- LOCATION AND INSTALLATION / VENTILATION
- BACKGUARD AND ACCESSORIES
- INSTALLATION OF ANTI-TIP DEVICE
- ELECTRICAL CONNECTIONS
- GAS CONNECTION
- FINAL SETUP
- SERVICE
- APPENDIX
- PRÉCAUTIONS DE SÉCURITÉ - AVANT DE COMMENCER
- NUMÉROS DE MODÈLE
- PLAQUE SIGNALÉTIQUE
- RESPECT DE LA RÉGLEMENTATION ET DES CODES EN VIGUEUR
- EMPLACEMENT ET INSTALLATION / VENTILATION
- DOSSERET ET ACCESSOIRES
- INSTALLATION DU DISPOSITIF ANTI-BASCULEMENT
- BRANCHEMENTS ÉLECTRIQUES
- RACCORDEMENT DE GAZ
- PHASE FINALE DE L’INSTALLATION
- SERVICE
- APPENDICE
EN
©2020 Hestan Commercial Corporation
15
INSTALLATION OF ANTI-TIP DEVICE
THE ANTI-TIP DEVICE PROVIDED WITH THIS RANGE
MUST BE INSTALLED.
PREPARATIONPREPARATION
POSSIBLE PROPERTY DAMAGE - Use a qualified installer or contractor to
determine the proper method of attaching the anti-tip bracket to the rear wall
or floor behind your range. Special drills or tools may be needed to drill holes in the wall or floor
(ceramic tile, hardwood flooring, etc.).
ELECTRICAL SHOCK HAZARD - Use extreme caution when drilling holes
into the wall or floor as there may be hidden wires. Identify the electrical
circuits that could be affected by the installation of the anti-tip bracket.
Shut off the power to these circuits. Failure to follow these instructions may result in death or
electrical shock.
HOLE PREPARATIONHOLE PREPARATION
The anti-tip bracket must be installed in sound materials, such as wood studs in the wall AND floor
joists under the finished floor. They must be able to withstand the forces exerted on the bracket by
the range should it tip-over. If wood studs or other suitable materials are not in the designated area
behind the range, you must attach the bracket using appropriate drywall anchors or similar fasteners.
DRYWALL INSTALLATION: After positioning the bracket as per the diagram below, mark the holes
and drill the appropriate holes as per the instructions supplied with the wall anchors. For hardboard
or solid plaster walls, you may need different wall anchors, available at your local hardware store or
home center.
WOOD FLOOR INSTALLATION: After positioning the bracket as per the diagram below, mark the
holes and drill the appropriate holes for #12 or similar, large wood screws, at least 1.5” [3.8 cm] in
length. Use washers as well. All hardware is available at your local hardware store or home center.
CONCRETE FLOOR INSTALLATION: After positioning the bracket as per the diagram below, mark
the holes and drill the appropriate holes for #12 or similar large masonry anchors, at least 1.5” [3.8 cm]
in length. Use washers as well. All hardware is available at your local hardware store or home center.
NOTICE
X
WOOD STUD
INSIDE WALL
CABINET
FLOOR
RANGE MODEL
XX
30”, 48” 1” [2.5]
36” 1-13-16” [4.6]