Installation Manual

LOCATION AND INSTALLATION / VENTILATION

GAS

SUPPLY

APPLIANCE

SHUTOFF VALVE

IN OPEN POSITION

The range is held onto the pallet with 4 large shipping bolts on both sides. Remove these bolts and

then move the range to the floor with the help of 2 persons.

PREPARATION

Before moving the range, protect any finished flooring and secure the oven door(s) closed to

prevent damage.

GAS AND ELECTRICAL SUPPLY CLEARANCES

If not already in place, install a gas shut-off valve in

an easily accessible location for servicing of the range.

Make sure all users of the range know where this shut-

off is located, and how to shut off the gas. Any openings

in the wall or floor behind the appliance must be sealed.

The Installation Clearances on the following pages show

where the “G” and “E” zones should be located.

The range is designed to be installed nearly flush to the

rear wall*. It may be necessary to reposition the gas

supply and power receptacle / junction box in order

to accommodate the range when pushed back against

the wall. The power supply cord when plugged in, or

junction box should protrude no more than 2-1/2” [6.4

cm] from the rear wall.

* Unless installed in an island with no rear wall.

CABINETRY

To eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space

located above the surface units should be avoided. If cabinet storage is to be provided, the risk can

be reduced by installing the required vent hood that projects horizontally a minimum of 5” [12.7

cm] beyond the bottom of the cabinets.