Installation Manual

SERVICE

All warranty and non-warranty repairs should be performed by qualified service personnel. To

locate an authorized service agent in your area, contact your Hestan dealer, local representative, or

Hestan. Before you call, please have the model number and serial number information on hand.

Hestan Commercial Corporation

3375 E. La Palma Avenue

Anaheim, CA 92806

(888) 905-7463

FINAL SETUP

(CONTINUED)

Verify ignition at each burner. Igniter will make a clicking sound until the flame lights within 4

seconds, then the clicking will stop. Check flame characteristics at each burner per the descriptions

below. Flames should be stable and not dance or lift off the burner ports. Flame may need to burn

for a few minutes to purge the gas lines of impurities. These appear as intermittent orange tips

or even tiny sparks in the flame. This is normal and the flame will eventually stabilize like those

shown in the image below.

If after a few minutes the flames continue to burn mostly yellow, verify that the burner head is

properly installed on top of the base, then retest. Use caution when handling the burner head.

They can be very hot.

Turn down the control knob to the simmer setting to check function.

Check each burner individually, then check they operate satisfactorily with other burners on.

Light blue flame - Natural gas normal flame

Light blue flame with yellow tips - LP gas normal flame

Yellow flame - Needs adjustment

If after all the above tests still result in mostly yellow flames, or the burners do not light, contact

Hestan customer service to schedule a service call.

GAS GRIDDLE

The gas griddle does not have flame/burner adjustments. Turn the control knob to HIGH, verify

that the griddle heats up. You may also notice a constant orange glow at the rear vents of the

griddle area. This is normal during operation of the griddle.

Turn all burners off when testing is complete.