Installation Manual

OVEN DOOR REMOVAL

If you have a very narrow door opening to your kitchen, the oven door(s) can be removed.

REMOVE ONLY IF ABSOLUTELY NECESSARY. Door removal should only be done by a certified

installer or service technician. Be sure the oven has completely cooled and the electrical power is

off. Failure to do so may result in electric shock or burn injury. Use caution when removing the

door, it is very heavy. Be careful to disconnect the wire inside the door.

1. Open oven door completely.

2. Locate cover near hinge to access wire connector inside. Using small needle-nose pliers and a

small flat-blade screwdriver, disconnect the wires inside the door. [ A ]

3. At each hinge location, swing the hinge clip forward until it stops. A screwdriver may be

needed to do this. [ B ]

4. Gently close the oven door until it stops against the hinge clips, or approximately 30° from the

closed position. Hold on firmly to both sides of the door (not the handle) and pull the door

straight up off the hinges. Ask an assistant to help direct the wires out of the bottom of the

door so it does not hang up on anything. Place the oven door in a safe location until needed.

NEVER release the hinge clips and try to close the hinges. Doing so will snap the hinges closed

with great force which could cause injury. [ C & D ]

COVER PLATE

AND SCREW

HINGE CLIP

Hinge

clip

LOCATION AND INSTALLATION/VENTILATION

(CONTINUED)

RE-INSTALL OVEN DOOR

1. Hold the door firmly on both sides (NOT FROM THE HANDLE) at approximately 30° from the

closed position and insert the hinges into the slots in the oven. The bottom edge of each hinge

has a notch which must seat inside the slot opening. DO NOT FORCE OR BEND OR TWIST

THE DOOR! [ E & F ]

2. Slowly open the door all the way. Swing the hinge clips away from you until completely inside

the slot opening and fully seated. A screwdriver may help you do this. [ G ]

3. Re-attach the wire connector and assure it is securely inside the door. Re-install the cover. [ H ]

4. Gently close the oven door to check for smooth operation.