Installation Guide

INSTALLATION OF ANTI-TIP DEVICE

(CONTINUED)

DRYWALL INSTALLATION: After positioning the bracket as per the diagram below, mark the holes

and drill the appropriate holes as per the instructions supplied with the wall anchors. For hardboard

or solid plaster walls, you may need different wall anchors, available at your local hardware store or

home center.

WOOD FLOOR INSTALLATION: After positioning the bracket as per the diagram below, mark the

holes and drill the appropriate holes for #12 or similar, large wood screws, at least 1.5” [3.8 cm] in

length. Use washers as well. All hardware is available at your local hardware store or home center.

CONCRETE FLOOR INSTALLATION: After positioning the bracket as per the diagram below, mark

the holes and drill the appropriate holes for #12 or similar large masonry anchors, at least 1.5” [3.8

cm] in length. Use washers as well. All hardware is available at your local hardware store or home

center.

ANTI-TIP BOLT ADJUSTMENT

After leveling the range, and after the bracket

has been attached, adjust the anti-tip bolt and

large washer under the range so the top of the

washer is 1-1/4” [3.2 cm] maximum from the

floor. Slide the range into the opening of the

bracket and verify the bolt is engaged in the

bracket as seen below. Carefully tip the range

forward to check. The range should not move

more than 1” [2.5 cm].