Installation Guide

EN
©2019 Hestan Commercial Corporation
5
OVEN DOOR REMOVAL
If you have a very narrow door opening to your kitchen, the oven door(s) can be removed. REMOVE
ONLY IF ABSOLUTELY NECESSARY. Door removal should only be done by a certified installer or
service technician. Be sure the oven has completely cooled and the electrical power is off. Failure
to do so may result in electric shock or burn injury. Use caution when removing the door, it is very
heavy.
1. Open oven door completely.
2. At each hinge location, swing the hinge clip forward until it stops. A screwdriver may be needed
to do this. [ B ]
3. Gently close the oven door until it stops against the hinge clips, or approximately 30° from the
closed position. Hold on firmly to both sides of the door (not the handle) and pull the door
straight up off the hinges. Place the oven door in a safe location until needed. NEVER release
the hinge clips and try to close the hinges. Doing so will snap the hinges closed with great force
which could cause injury. [ C & D ]
Hinge
clip
A
B
Hinge
clip
C
G
Hinge
clip
H
LOCATION AND INSTALLATION/VENTILATION (CONTINUED)
RE-INSTALL OVEN DOOR
1. Hold the door firmly on both sides (NOT FROM THE HANDLE) at approximately 30° from the
closed position and insert the hinges into the slots in the oven. The bottom edge of each hinge
has a notch which must seat inside the slot opening. DO NOT FORCE OR BEND OR TWIST
THE DOOR! [ E & F ]
2. Slowly open the door all the way. Swing the hinge clips away from you until completely inside
the slot opening and fully seated. A screwdriver may help you do this. [ G ]
3. Gently close the oven door to check for smooth operation.
F