Manualshelf

Installation Manual

ManualsBrandsHestan ManualsCooking Appliances36 Inch Gas Rangetop with 4 Sealed Burners, 12 Inch Infrared Griddle, Cast-Iron Continuous Grates, Simmer Flame, Marquise™ Control Panel, Dual-Flow Burner System, and Backlit Control Knobs: Citra, Liquid Propane
12345678910
©2018 Hestan Commercial Corporation
1
EN
1 SAFETY PRECAUTIONS - BEFORE YOU BEGIN
2 MODEL NUMBERS
3 RATING LABEL
3 REGULATORY / CODE REQUIREMENTS
3 LOCATION AND INSTALLATION / VENTILATION
7 BACKGUARD AND ACCESSORIES
8 ELECTRICAL CONNECTIONS
8 GAS CONNECTIONS
10 FINAL SETUP
11 SERVICE
12 APPENDIX
TABLE OF CONTENTS
When properly cared for, your Hestan appliance will provide safe, reliable service for many years.
When using this appliance, basic safety practices must be followed as outlined below.
IMPORTANT: Save these instructions for the local Gas or Utility Inspector’s use.
INSTALLER: Please leave these Installation Instructions with the owner.
OWNER: Please retain these Installation Instructions for future reference.
This rangetop is NOT designed for installation in manufactured (mobile) homes or recreational park
trailers. Do NOT install this rangetop outdoors.
SAFETY PRECAUTIONS - BEFORE YOU BEGIN
ELECTRICAL SHOCK HAZARD
Disconnect power before installing or servicing appliance. Before turning
power ON, be sure all controls are in the OFF position. Failure to do so can
result in electrical shock or death.
ELECTRICAL GROUNDING
This appliance must be grounded. Grounding reduces the risk of electric
shock in the event of a short circuit. Read the ELECTRICAL CONNECTIONS
section of this manual for complete instructions.
This appliance is equipped with a 3-prong grounding plug for your protection against shock hazard
and should be directly plugged into a properly grounded receptacle. Do not cut or remove the
grounding prong from this plug.
ELECTRICAL SUPPLY
The appliance must be on its own dedicated circuit - 120 VAC, Single Phase, 60 Hz, with a current
rating of 15 Amps. Have the installer show you where the electric circuit breaker is located so
you know how to shut off the power to this appliance. It is the responsibility of the user to have
the appliance connected by a licensed electrician in accordance with all local codes, or in the
absence of local codes, in accordance with the National Electrical Code. Read the ELECTRICAL
CONNECTIONS section of this manual for complete details.