Installation Guide

FINAL INSTALLATION (CONT.)
MOVING SINGLE UNIT INTO POSITION
Side connectors with decorative trim pieces are provided to secure the appliance to adjacent
cabinetry.
Make sure the side connectors will fit the
cutout width. See "CHECK/ADJUST SIDE
TRIM" on page 30.
All but KRP: The unit does not need a
ventilation shaft in the cabinet for cooling.
KRP: See "INSTALLATION CUT-OUT - KRP
MODELS" on page 5 for ventilation
requirements.
Always mount front panels on the door and
drawer before pushing the unit into its final
position inside the enclosure.
1) Move the unit into its final position
2) Check the leveling of the appliance,
adjusting the feet and wheels to correct it
if necessary.
3) Secure the appliance to the adjacent
cabinets using the side profiles. (2)
To make this operation easier keep the
door and the drawer open.
4) Mount the trim covers (3) by first inserting
them laterally then pushing firmly until a
“click” is heard.
1
3
2
2019 Hestan Commercial Corporation
29
EN