Installation Sheet
Table Of Contents
- SAFETY PRECAUTIONS - BEFORE YOU BEGIN
- MODEL NUMBERS
- RATING LABEL
- REGULATORY / CODE REQUIREMENTS
- LOCATION AND INSTALLATION
- ELECTRICAL CONNECTIONS
- FINAL SETUP
- SERVICE
- PRÉCAUTIONS DE SÉCURITÉ - AVANT DE COMMENCER
- NUMÉROS DE MODÈLE
- PLAQUE SIGNALÉTIQUE
- RESPECT DE LA RÉGLEMENTATION ET DES CODES EN VIGUEUR
- EMPLACEMENT ET INSTALLATION
- BRANCHEMENTS ÉLECTRIQUES
- PHASE FINALE DE L’INSTALLATION
- SERVICE
©2019 Hestan Commercial Corporation
2
EN
MODEL NUMBERS
RATING LABEL
The rating label contains important information about your
Hestan appliance such as the model and serial number, electrical
rating and the minimum installation clearances.
The rating label is located on the left side of the oven cavity
opening near the door hinge.
If service is necessary, contact Hestan Customer Service with the
model and serial number information shown on the label.
OVEN MODELS
MODEL NO. DESCRIPTION
CIRCUIT BREAKER
REQ’D
KSO 30 30” Single Wall Oven 20 Amp
KDO 30 30” Double Wall Oven 40 Amp
REGULATORY / CODE REQUIREMENTS
Installation of this cooking appliance must be made in accordance with local codes. In the
absence of local codes, this unit should be installed in accordance with the National Electrical
Code and local codes.
This appliance must be electrically grounded in accordance with local codes or in the absence
of local codes with the National Electrical Code
ANSI/NFPA 70
, or Canadian Electrical code
CSA C22.1
.
RATING LABEL
KDO30
HESTAN COMMERCIAL CORP.
ANAHEIM, CA - USA
TYPICAL RATING LABEL