Installation Manual

ManualsBrandsHestan ManualsCooking Appliances30 Inch Single Wall Oven with TwinVection™ Technology, Touch Control Display, Porcelain Enamel Interior, Soft Close Door, 9 Oven Modes, Marquise Accented™ Handle, Backlit Knobs and 4.4 cu. ft. Oven Capacity: Matador

ELECTRICAL CONNECTIONS

ELECTRICAL SHOCK HAZARD

Disconnect power before installing or servicing appliance. Before turning

power ON, be sure all controls are in the OFF position. Failure to do so can

result in death or electrical shock.

ELECTRICAL GROUNDING

This appliance must be grounded. Grounding reduces the risk of electric shock in the event of

a short circuit. Grounding through the neutral conductor is prohibited for new branch circuit

installations (1996 NEC), mobile homes, and recreational vehicles, or in an area where local

codes prohibit it. This oven has been setup at the factory for a 4-wire connection.

Improper grounding will cause malfunctions in the unit and create a shock hazard condition.

ELECTRICAL CONNECTION

The appliance must be on its own dedicated circuit - 240 VAC, Single Phase, 60 Hz, or 208

Volt, 60Hz, with a current rating as shown in the Model listing on page 2.

NOTE: FOR USE WITH 208 V, 60 HZ SUPPLY VOLTAGE, SEE “CONNECTING TO 208

VOLT CIRCUIT” on page 10.

For hook-up of the oven you will need to have an approved junction box installed where it

will be easily reached through the front of the cabinet where the oven will be located.

The oven has 3 ft. [91 cm] of flexible conduit. DO NOT shorten the conduit. Allow of 2 to 3

ft. [61-91 cm] of slack so that the oven can be moved if servicing is ever necessary.

For both US and CANADA installations: This appliance is

equipped with copper lead wires and must be connected to

copper wires only. Improper connection of aluminum house

wiring can result in a fire or shock hazard. Use only connectors

designed and certified for connecting to aluminum wire, and

installed by a qualified electrician.

4-WIRE CONNECTION

For installations where grounding through the neutral conductor is prohibited.

1. Make sure power is off at the supply panel / breaker.

2. Attach GREEN ground appliance wire to

bare or GREEN wire in electrical box.

3. Connect WHITE neutral appliance wire

to WHITE neutral wire in electrical box.

4. Connect RED (L1) appliance wire to

RED red power wire in electrical box.

5. Connect BLACK (L2) appliance wire to

BLACK power wire in electrical box.

Red wires

Junction box

Cable from power supply

White

wires

Black

wires

UL listed conduit

connector

Cable

from oven

Bare or

green wire

4-WIRE CONNECTION