Manualshelf

Use and Care

ManualsBrandsHestan ManualsCooking Appliances30 Inch Single Wall Oven with TwinVection™ Technology, Touch Control Display, Porcelain Enamel Interior, Soft Close Door, 9 Oven Modes, Marquise Accented™ Handle, Backlit Knobs and 4.4 cu. ft. Oven Capacity: Matador
31323334353637383940
TO SET THE SELF-CLEAN MODE
1. Touch [UPPER/LOWER] key to select the cavity to be cleaned, if the oven is a double.
2. Rotate both knobs into the clean position.
3. CLEAN & TIME appear. This is the clean time, its standard value is 3 hours.
4. If desired, adjust the cleaning time per instructions below.
5. When the cleaning time is accepted, the door will begin to lock.
• The “AUTO LOCK” message will flash until the door is locked.
6. When AUTO LOCK stops flashing, check that the door has been locked and will not open.
7. If door does not lock, rotate the cooking mode knob into the OFF position and do not start
self-clean; contact Hestan Customer Care for service.
• Provide good ventilation to the room during and immediately after self-cleaning the oven.
• To stop the cleaning mode at any moment, move either of the two knobs from the cleaning
position.
• At the end of the programmed cleaning time, the oven will automatically turn off.
TO CHANGE THE CLEANING TIME
1. To change the setting from 3 hours, select either 2 hours for light soil or 4 hours for heavy
soil immediately before starting.
2. To change the hours, touch the TIME key.
3. The hours will flash.
4. Use + or - keys to change the value.
5. To change the minutes, touch the TIME key again.
6. The minutes will flash.
7. Use + or - keys to change the value. Hold the key to change by 10 minutes steps.
8. Touch TIME or wait a few seconds to confirm the new value.
TO DELAY THE START OF CLEANING
1. Follow steps 1 through 7 above.
2. Touch the TIME key and verify that “STOP TIME” appears on the display. The hours will
begin flashing.
3. Use + or - keys to change the stop time value.
4. To change the minutes, touch the TIME key, the minutes will flash.
5. Use + or - keys to change the value. Hold the key to change by 10 minutes steps.
6. Touch TIME or wait a few seconds to confirm the new value.
The latch starts moving to lock the oven door, the display shows “DELAY”..
When the delay time expires, self-cleaning will start.
At the end of the programmed cleaning time, the oven will automatically turn off.
“End” will appear on the temperature display, “CLEAN” on the mode display and “TIME” on the
clock display will start flashing until the
TIME key is touched or the knob is moved to the OFF
position.
• In order to check the cleaning or the stop time during a delayed clean, simply touch the
TIME key until “TIME” or “STOP TIME” message is displayed.
OVEN CARE AND CLEANING
(CONT.)
©2018 Hestan Commercial Corporation
34
EN