Installation Manual

ManualsBrandsHestan ManualsCooking Appliances36 Inch Pro Canopy Range Hood with CircuFlow Ventilation System™, 600 CFM Blower, Dishwasher Safe Components, LED Lighting and Marquise™ Accented Profile: Tin Roof

INSTALLATION

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO

PERSONS, OBSERVE THE FOLLOWING:

a) Installation work and electrical wiring must be done by qualified person(s) in accordance with

all applicable codes and standards, including fire-rated construction.

b) Sufficient air is needed for proper combustion and exhausting of gases through the flue

(chimney) of fuel burning equipment to prevent back drafting. Follow the heating equipment

manufacturer’s guideline and safety standards such as those published by the National Fire

Protection Association (NFPA), and the American Society for Heating, Refrigeration, and Air

Conditioning Engineers (ASHRAE) and the local code authorities.

c) When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden

utilities.

d) Ducted fans must always be vented to the outdoors.

TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.

TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT USE THIS BLOWER WITH

ANY SOLID-STATE SPEED CONTROL DEVICE.

INSTALLATION DETAILS

1. Read all instructions thoroughly before beginning installation. Note: These instructions apply

to Hestan’s standard hoods only. Custom hoods may require additional consideration.

• See “DUCTING DO’S AND DON’TS” on page10.

• Weight and size: For safe installation, at least two people should be present to lift and hold the

hood. For larger hoods and installations with duct covers, it is advisable to have a third person

present to assist.

• Back Venting: If venting out the wall behind the vent instead of venting through the ceiling, see

“Back Venting” on page17 for particulars.

2. When installing a wall mount range hood, it is recommended that the bottom edge of the hood

be located no more than 30” above the cooking surface for optimum performance.

3. Select the appropriate installation method.

Method 1 is suitable for applications where the top of the hood

(blower outlet(s) location) is accessible after the hood is mounted

on the wall and when a Hestan duct cover will be used.

• NOTE: Since Hestan duct covers can be opened for access, they

can be installed with the hood and still permit access to connection

points. The duct cover frame requires that the hood and duct cover be

installed together.

Method 2 is suitable for applications where the top of the hood

(blower outlet(s) location) is not accessible after the hood is

mounted on the wall.

CAUTION

Make sure that once the hood is mounted the

motor cooling vents are not obstructed.

4. IF THE HOOD IS TO BE “BACK VENTED”, PROCEED DIRECTLY TO

STEP 5.

Consult the connection diagrams (following) for further details on

exhaust outlet placement.

Optional duct

cover

18”

30”

36”