Installation Manual

PREPARING THE INSTALLATION

(continued)

LOCATION AND INSTALLATION

To remove the front xing bracket

Remove the xing brackets

truck, remove the appliance and place it on the oor.

Be very careful to avoid any damage to oors. Delicate oors should be

Transport to installation site

and unpacking

Since this is a large and heavy appliance, before transporting the ap-

pliance, check the access to the location where it will be installed

(door size, maneuvering space in stairwells, etc.).

The appliance is attached to the base of the packaging (pallet) through

four bolts which can be removed using a 17 mm (3/4”) wrench.

It is recommended to use a manual transporting device to move the

appliance to the installation site, and only at this point to remove the

base of the packaging.

The appliance should always be transported in a vertical position.

If this is not possible, transport the appliance laying on its rear side.

Once at the installation site, the appliance, which is equipped with four

wheels, can be taken off the pallet and positioned in the installation

area.

Operate as follows:

Take off the four bolts

securing the appliance to the pallet by

means of a 17 mm (3/4”) wrench.

and

, unscrew for one or two turns

the rear wheel adjusting bolt

by means of a 13 mm (1/2”) wrench.

From the back of the unit and by means of a suitable, high duty hand

protected with plywood, hard cardboard or similar material panels.

The appliance is very heavy.

Take maximum care during handling to

avoid injury.

The appliance should always be transported

in a vertical position.

Avoid at all costs leaning it on its front side.