User's Manual

Receiver Safe Mode
The following conditions cause the receiver to go into its Safe mode:
• The transmitter goes into Sleep Mode
• Radio signal interference
• Transmitter out of operating range
• E-Stop button is activated
• E-Stop circuit failure
• Low battery sends E-stop after time out
When the transmitter signal is no longer sensed by the receiver, the Time Out process begins.
The Time Out period is set to
450 msec at the factory. If the receiver does not establish contact with the transmitter within that
time period, it goes into the
Safe Mode. In Safe Mode, the receiver shuts off power to the output modules and activates the
E-stop function. To restart the
system, be sure the transmitter signal is active and sensed by the receiver. Then press the
Start/Horn pushbutton.
Installation
Pre-Installation Precautions
1. Make sure the transmitter and receiver have identical ADMO numbers and
channels.
2. Make sure the receiver is not set to the same channel as any other systems in
use in the surrounding area.
3. Make sure that the controller or equipment is working properly prior to radio
remote control installation.
4. Make sure the power source to the receiver is set correctly.
5. Switch off the main power source to the controller or equipment prior to
installation.