User Manual
Table Of Contents
- Computer features
- Troubleshooting
- Computer Setup (F10) Utilities
- Changing BIOS Settings from the HP BIOS Configuration Utility (HPBCU)
- Updating or restoring a BIOS
- Diagnostics and troubleshooting LEDs
- Wake-on LAN
- Startup sequence
- Resetting the setup and power-on passwords
- Power-on diagnostic tests
- Interpreting POST diagnostic front panel lights and audible codes
- Basic troubleshooting
- No-disc (no-flash) computer troubleshooting
- Configuring a PXE server
- Using HP ThinUpdate to restore the image
- Device management
- Statement of Volatility
- Using HP PC Hardware Diagnostics
- Power cord set requirements
- Computer operating guidelines, routine care, and shipping preparation
- Specifications
- Electrostatic discharge
- Accessibility
- Index
Lay the thin client down with the right side up and locate the two screw holes in the grid on the
right side of the thin client.
Position the stand over the side of the thin client (1) and line up the captive screws in the stand
with the screw holes in the thin client (2).
Tighten the captive screws securely.
7. Reconnect the AC power cord and then turn the thin client on.
NOTE: Be sure that at least 10.2 centimeters (4 inches) of space on all sides of the thin client remain
clear and free of obstructions.
8. Lock any security devices that were disengaged when the thin client cover or access panel was removed.
Securing the thin client
Your thin client is designed to accept a security cable. The security cable prevents unauthorized removal of
the thin client, as well as preventing access to the secure compartment.
To order this option, go to the HP website at http://www.hp.com and search for your specic thin client.
1. Locate the security cable slot on the back panel.
Setup 13