User Manual
Table Of Contents
- Table of Contents
- Introduction
- Menu Overview and Basic Setup
- Using a Network-Connected Machine
- Printing
- Copying
- Scanning
- Faxing
- Useful Setting Menus
- Maintenance
- Ordering supplies and accessories
- Available supplies
- Available maintenance parts
- Storing the toner cartridge
- Redistributing toner
- Replacing the toner cartridge
- Replacing the imaging drum
- Replacing the toner collection unit
- Monitoring the supplies life
- Setting the toner low alert
- Cleaning the machine
- Tips for moving & storing your machine
- Troubleshooting
- Tips for avoiding paper jams
- Clearing original document jams
- Clearing paper jams
- Understanding the LEDs
- A “Low Toner” or “Very Low Toner” message displays in Supplies information report
- Understanding display messages
- Paper feeding problems
- Power and cable connecting problems
- Solving other problems
- Solve wireless network problems
- Wireless connectivity checklist
- The printer does not print after the wireless configuration completes
- The printer does not print, and the computer has a third-party firewall installed
- The wireless connection does not work after moving the wireless router or printer
- Cannot connect more computers to the wireless printer
- The wireless printer loses communication when connected to a VPN
- The network does not appear in the wireless networks list
- The wireless network is not functioning
- Perform a wireless network diagnostic test
- Appendix
- Glossary
- Index
Machine’s basic settings | 35
Machine’s basic settings
You change the machine’s setting set in the machine from HP Embedded Web Server.
If your machine is connected to the network, you can set the
machine’s setting from HP Embedded Web Server > Settings tab > Machine Settings (see
"Using HP Embedded Web Server" on page 66).
Machine’s default settings
After installation is complete, you may want to set the machine's default settings.
To change the machine’s default settings, follow these steps:
It may be necessary to press OK to navigate to lower-level menus for some models.
1 Select (Menu) button on the control panel.
2 Press System Setup > Machine Setup.
3 Select the option you want, then press OK.
4 Select the sub option you want, then press OK.
5 Press OK to save the selection.
6 Press (Cancel) to return to ready mode.