User Manual
Table Of Contents
- Table of Contents
- Introduction
- Menu Overview and Basic Setup
- Using a Network-Connected Machine
- Printing
- Copying
- Scanning
- Faxing
- Useful Setting Menus
- Maintenance
- Ordering supplies and accessories
- Available supplies
- Available maintenance parts
- Storing the toner cartridge
- Redistributing toner
- Replacing the toner cartridge
- Replacing the imaging drum
- Replacing the toner collection unit
- Monitoring the supplies life
- Setting the toner low alert
- Cleaning the machine
- Tips for moving & storing your machine
- Troubleshooting
- Tips for avoiding paper jams
- Clearing original document jams
- Clearing paper jams
- Understanding the LEDs
- A “Low Toner” or “Very Low Toner” message displays in Supplies information report
- Understanding display messages
- Paper feeding problems
- Power and cable connecting problems
- Solving other problems
- Solve wireless network problems
- Wireless connectivity checklist
- The printer does not print after the wireless configuration completes
- The printer does not print, and the computer has a third-party firewall installed
- The wireless connection does not work after moving the wireless router or printer
- Cannot connect more computers to the wireless printer
- The wireless printer loses communication when connected to a VPN
- The network does not appear in the wireless networks list
- The wireless network is not functioning
- Perform a wireless network diagnostic test
- Appendix
- Glossary
- Index
Media and tray | 46
(●: Supported, Blank: Not supported)
Labels
To avoid damaging the machine, use only labels designed for use in laser printers.
• When selecting labels, consider the following factors:
- Adhesives: Should be stable at your machine’s fusing temperature about 170°C (338°F).
- Arrangement: Only use labels with no exposed backing between them. Labels can peel off
sheets that have spaces between the labels, causing serious jams.
- Curl: Must lie flat with no more than 13 mm of curl in any direction.
- Condition: Do not use labels with wrinkles, bubbles, or other indications of separation.
• Make sure that there is no exposed adhesive material between labels. Exposed areas can cause
labels to peel off during printing, which can cause paper jams. Exposed adhesive can also cause
damage to machine components.
• Do not run a sheet of labels through the machine more than once. The adhesive backing is
designed for only a single pass through the machine.
• Do not use labels that are separating from the backing sheet or are wrinkled, bubbled, or
otherwise damaged.
X-Hvy 121-163 ●
Labels ●
Preprinted ●
Recycled ●
Glossy111-130g ●
Glossy131-175 g ●
Glossy176-220 g ●
HP Matte 120 g ●
HP Matte 150 g ●
HP Matte 200 g ●
a.The paper types available manual feeding in tray.
Types Tray
a