User Manual
Table Of Contents
- Table of Contents
- Introduction
- Menu Overview and Basic Setup
- Using a Network-Connected Machine
- Printing
- Copying
- Scanning
- Faxing
- Useful Setting Menus
- Maintenance
- Ordering supplies and accessories
- Available supplies
- Available maintenance parts
- Storing the toner cartridge
- Redistributing toner
- Replacing the toner cartridge
- Replacing the imaging drum
- Replacing the toner collection unit
- Monitoring the supplies life
- Setting the toner low alert
- Cleaning the machine
- Tips for moving & storing your machine
- Troubleshooting
- Tips for avoiding paper jams
- Clearing original document jams
- Clearing paper jams
- Understanding the LEDs
- A “Low Toner” or “Very Low Toner” message displays in Supplies information report
- Understanding display messages
- Paper feeding problems
- Power and cable connecting problems
- Solving other problems
- Solve wireless network problems
- Wireless connectivity checklist
- The printer does not print after the wireless configuration completes
- The printer does not print, and the computer has a third-party firewall installed
- The wireless connection does not work after moving the wireless router or printer
- Cannot connect more computers to the wireless printer
- The wireless printer loses communication when connected to a VPN
- The network does not appear in the wireless networks list
- The wireless network is not functioning
- Perform a wireless network diagnostic test
- Appendix
- Glossary
- Index
Media and tray | 50
Using the output support
The surface of the output tray may become hot if you print a large number of pages at
once. Make sure that you do not touch the surface, and do not allow children near it.
The printed pages stack on the output support, and the output support will help the printed pages
to align. The printer sends output to the output tray by default.
Illustrations on this user’s guide may differ from your machine depending on its options
or models. Check your machine type (see "Front view" on page 21).
Preparing originals
• Do not load paper smaller than 76 x 148.5 mm (3 x 5.85 inches) or larger than 216 x 356 mm (8.5
x 14 inches).
• Do not attempt to load the following s of paper, in order to prevent paper jam, low print quality
and machine damage.
- Carbon-paper or carbon-backed paper
- Coated paper
- Onion skin or thin paper
- Wrinkled or creased paper
- Curled or rolled paper
- Torn paper
• Remove all staples and paper clips before loading.
• Make sure any glue, ink, or correction fluid on the paper is completely dry before loading.
• Do not load originals that include different sizes or weights of paper.
• Do not load booklets, pamphlets, transparencies, or documents with other unusual
characteristics.