User Manual
Table Of Contents
- Table of Contents
- Introduction
- Menu Overview and Basic Setup
- Using a Network-Connected Machine
- Printing
- Copying
- Scanning
- Faxing
- Useful Setting Menus
- Maintenance
- Ordering supplies and accessories
- Available supplies
- Available maintenance parts
- Storing the toner cartridge
- Redistributing toner
- Replacing the toner cartridge
- Replacing the imaging drum
- Replacing the toner collection unit
- Monitoring the supplies life
- Setting the toner low alert
- Cleaning the machine
- Tips for moving & storing your machine
- Troubleshooting
- Tips for avoiding paper jams
- Clearing original document jams
- Clearing paper jams
- Understanding the LEDs
- A “Low Toner” or “Very Low Toner” message displays in Supplies information report
- Understanding display messages
- Paper feeding problems
- Power and cable connecting problems
- Solving other problems
- Solve wireless network problems
- Wireless connectivity checklist
- The printer does not print after the wireless configuration completes
- The printer does not print, and the computer has a third-party firewall installed
- The wireless connection does not work after moving the wireless router or printer
- Cannot connect more computers to the wireless printer
- The wireless printer loses communication when connected to a VPN
- The network does not appear in the wireless networks list
- The wireless network is not functioning
- Perform a wireless network diagnostic test
- Appendix
- Glossary
- Index
Wired network setup | 56
IPv6 is supported properly only in Windows Server or higher.
The machine supports the following IPv6 addresses for network printing and managements.
• Link-local Address: Self-configured local IPv6 address (Address starts with FE80).
• Stateless Address: Automatically configured IPv6 address by a network router.
• Stateful Address: IPv6 address configured by a DHCPv6 server.
• Manual Address: Manually configured IPv6 address by a user.
In the IPv6 network environment, follow the next procedure to use the IPv6 address.
Activating IPv6
1 Press the (Menu) button on the control panel.
2 Press Network > TCP/IP (IPv6) > IPv6 Protocol
3 Select On and press OK.
4 Turn the machine off and turn it on again.
DHCPv6 address configuration
If you have a DHCPv6 server on your network, you can set one of the following options for default
dynamic host configuration.
1 Press the (Menu) button on the control panel.
2 Press Network > TCP/IP (IPv6) > DHCPv6 Config
3 Press OK to select the required value you want.